Avtech 35X series Uživatelský manuál stáhnout pdf (Strana 5)

1. CAMERA NETWORK CONFIGURATIONS

Please follow the instructions below to finish camera installation and network configurations.

You may configure the network connection of this network camera with your laptop / computer, or with your iPhone®

or iPad® based on your network environment.

1.1 Cable Overview

1.2 Assemble & Install Camera

Step1: Paste the installation sticker supplied with the camera to where to install the camera, and position the four

holes for screws. Drill the two screws at top to the wall. ( and as shown below)

Note: Please leave some space between the screws and wall. Do not get them to the end

Step2: Hang the camera at the screws you just fixed,

and make sure the camera stays in place.

Step3: Decide the cable direction (up / down) before

you fasten the screws tight to the wall.

Step4: Drill the rest of screws into the wall. After that, make sure all screws are fastened.

Step5: Adjust the angle of the camera (up / down / left / right) with the supplied wrenches for better viewing.

1 2 3 4 5 6 7 8 9 10 ... 22 23

Žádné komentáře

Avtech 35X series Uživatelský manuál Strana 5